VINAL CRACK FILL PASTE
VINAL CRACK FILL PASTE
Vinal Crack Fill Paste is a single pack, ready to use flexible putty for filling the cracks in plastered surface.
PERFORMANCE FEATURES & BENEFITS:
- Easily applicable by putty knife like conventional putties.
- Excellent adhesion to common building substrates other than glass.
- Non- sagging.
- Flexible and hence can accommodate minor movements in cracks.
- Non – staining.
- Can be tinted with water based strainers.
- Overcoatable with any kinds of polymer based paints after 24 hours.
- Non –toxic and safe on hands.
- Water based having negligible VOC, hence eco friendly.
External and internal plastered brick masonry wall cracks of up to 5mm width.
DIRECTIONS FOR USE:
Clean the crack from any kind of laitance, grease, oils, wax, polish etc. remove loose particles from joints. The edge of the cracks / joints should be neat and sound. Make sure the surface is free from puddles of water. Moisten the crack surface before applying Vinal Crack Fill Paste. Fine hairline cracks must be winded up to 1 mm minimum followed by filling. For filling Vinal Crack Filling Paste on the internal surface existing painter’s putty or POP must be removed till plaster surface is exposed. For porous surfaces, apply primer coat prepared with Vinal Crack Fill Paste and water in 1 : 1 proportion over the crack. Fill Vinal Crack Fill Paste when the surface is tacky but not dried completely.
Press Vinal Crack Fill Paste into the cracks using a putty knife or spatula. Level the surface with a putty knife to get a smooth and clean surface. Care must be taken to avoid formation of cavities / bubbles during application. A further coat of Vinal Crack Fill Paste is undertaken after 4 hours of the application, when the first coat of Vinal Crack Fill Paste is completely cured. Painter’s putty or POP can be taken up once it is fully dry. For best results allow Vinal Crack Fill Paste to cure for 7 Days.
Strictly not recommended to fill the cracks more than 5 mm. strictly not recommended for filling structural cracks, expansion joints, separation gaps etc. or any type of dynamic cracks. Not for cracks in POP or paint’s putty. For application below 10oC, drying time will be delayed. Container to be tightly closed after application. Clean tools and hands with soap and warm water.
|Full curing time @30oC||:||7 days|
|Density||:||Around 1.40 gm / cc|
Best before 12 months from the date manufacturing in unpacked condition.
Store in cool and dry place, away from direct sunlight.
Approx 25-30running meter / kg.
500 Grams, 1 Kg, 5 Kg.
HEALTH AND SAFETY PRECAUTIONS:
While using Vinal Crack Fill Paste use rubber hand gloves, dust mask, and safety goggles. In case of contact with skin, wash thoroughly with plenty of clean water. If accidentally swallowed, immediately seek medical advice. Do not induce vomiting. Keep out of children’s reach.